Velvet Hijab Fabric: Which Weight Actually Works Against the Skin

Burnout velvet fabric in a light weight suitable for hijab production, showing open motif structure

Velvet Hijab Fabric: Which Weight Actually Works Against the Skin

For a hijab, the usable velvet weight range is 170–220 GSM, not the 250 GSM used for abaya and kaftan. A standard 180 × 70 cm hijab cut from 250 GSM velvet weighs about 315 g; the same hijab in 170 GSM burnout velvet weighs about 214 g. Worn for a full day, that 100 g difference is the difference between a fabric that stays put and one the wearer keeps adjusting. Our recommendation for hijab production is MJ-VBR01 burnout velvet, 80% viscose / 20% nylon, 170–220 GSM, 140 cm usable width — the same base cloth we supply for dirac and abaya, specified at the lighter end of its weight band.

Three properties decide whether a velvet works as a hijab: weight (does it stay on the head without pinning), surface friction (does it slide against hair or against itself), and shedding (does the pile come off on the face). All three are set by the base cloth and the finishing, not by the colour or the pattern. Below is how each one is specified, and the arithmetic a buyer needs to cost a hijab order from a fabric order.

H2 · The weight arithmetic, before anything else

A hijab is a small garment made from a large piece of cloth, so weight per square metre converts directly into weight on the head.

Hijab size Area at 170 GSM at 200 GSM at 250 GSM
180 × 70 cm (rectangular, most common) 1.26 m² 214 g 252 g 315 g
175 × 75 cm 1.31 m² 223 g 262 g 328 g
200 × 75 cm 1.50 m² 255 g 300 g 375 g
110 × 110 cm (square) 1.21 m² 206 g 242 g 303 g
140 × 140 cm (square, full-width) 1.96 m² 333 g 392 g 490 g

Two things follow from this table.

First, 250 GSM is out for rectangular hijabs. At 315 g a 180 × 70 cm piece is roughly the weight of a light sweater on your head. It photographs beautifully and it sells in a shop, but the returns come back with the same complaint: too heavy, keeps slipping, too warm.

Second, the 140 × 140 cm square is a different product. At full width it uses the entire 140 cm usable width with zero waste, which makes it the most efficient cut we can offer — but at 250 GSM it lands near 490 g and no finishing fixes that. If a buyer wants full-width squares, they should specify 170 GSM.

H2 · Surface friction: which way the pile faces

Velvet has a direction. The pile can face the hair or face out, and this single decision does more for whether a hijab stays in place than any pin or under-cap.

  • Pile facing the hair (pile-in): higher friction against hair, holds position with minimal pinning, and the smooth back sits against the forehead. This is what most production hijabs do. The trade-off is that the pile-in side traps warmth, so pile-in is a winter specification.
  • Pile facing out (pile-out): the lustre and the colour depth are visible, which is what the retail photo needs. Friction against hair is lower, so it needs an under-cap or a pin.

There is no fabric fix that gives both. A buyer ordering one colourway for a market that wears hijab year-round should expect to order it twice — pile-in for winter, a lighter pile-out quality for summer — rather than trying to make one cloth do both.

H2 · Shedding: the failure that gets returned

Pile shedding on a hijab is not a cosmetic problem. Loose fibres end up on the face and on the eyelashes, and it is one of the few velvet complaints that a customer cannot work around.

Three things control it:

  1. Pile height and density. A shorter, denser pile sheds less. This is set at weaving, not at finishing — it cannot be corrected later.
  2. Finishing sequence. Shearing and brushing after dyeing remove the loose fibre that would otherwise migrate. A cheap velvet skips the final brushing pass because it costs a pass through the line.
  3. Cut edge treatment. Burnout velvet has burned-open motif edges. Those edges are stable by construction — the burn seals them — but the ground between motifs is sheer and has to be handled as a lightweight fabric on the cutting table.

What a buyer should ask for: a four-point roll inspection record, and a finished-goods rubbing test on the pile side. Our standard inspection is AQL 2.5 in-line plus a four-point roll check, and both records travel with the shipment.

H2 · Colour fastness against skin, not against a lab card

A hijab sits against skin that sweats. Standard colour-fastness testing is done against multifibre strip, which is the right test for a garment but understates the problem for a head covering.

Ask for:

  • Perspiration fastness (acid and alkaline), not just wash fastness
  • Rubbing fastness, dry and wet, on the pile side — the pile side is the side that touches skin when worn pile-in
  • Light fastness if the colourway will be worn outdoors in a high-UV market

For a dark colourway — black, navy, deep burgundy — perspiration fastness is the one that generates complaints, and it is the one most often missing from a supplier's test report.

H2 · How many hijabs fit in a fabric order

This is the arithmetic buyers ask for and suppliers rarely publish.

At 140 cm usable width, a 70 cm-wide rectangular hijab cuts two across with no waste:

1 running metre of fabric  →  2 pieces of 70 cm width
180 cm long hijab          →  1.80 m of fabric  →  2 finished hijabs

So 1.80 m of velvet yields 2 hijabs of 180 × 70 cm. A 300 m minimum order therefore yields about 333 hijabs before cutting loss; allow 3–5% for end-of-roll and defect cuts, so plan on 315–325 finished pieces.

For 140 × 140 cm squares, one square uses one full metre of width and 1.40 m of length:

1.40 m of fabric  →  1 square hijab of 140 × 140 cm
300 m order       →  about 214 squares, before cutting loss

For 110 × 110 cm squares, one width cuts one square with 30 cm left over — enough for a narrow rectangular piece or a trim:

1.10 m of fabric  →  1 square of 110 × 110 cm  (+ 30 cm width offcut)

H2 · Seasonal timing

Velvet hijab demand is seasonal and it front-loads. Retail buying for winter and for Ramadan closes 10–14 weeks before the selling season, which means fabric has to be on a boat roughly 8–10 weeks before that.

Our lead time on a stock colourway is about 15 days; a developed colour or a buyer's own motif adds development time on top. Working back from a winter season, the fabric order needs to be placed by late August for a November retail floor.

H2 · What we actually recommend

Requirement Specification
Base cloth MJ-VBR01 burnout velvet, 80% viscose / 20% nylon
Weight for rectangular hijab 170–200 GSM
Weight for 140 × 140 square 170 GSM
Usable width 140 cm
Pattern 73 designs in the library (BR-01 to BR-73), or developed from buyer artwork
Colour any colourway in the library, or matched to a submitted standard
MOQ 300 m per colour
Lead time about 15 days on stock colours
Inspection AQL 2.5 in-line, four-point roll check, records supplied

If a buyer wants a solid rather than a burnout, the same arithmetic applies but the weight floor moves up: MJ-VSL01 solid-dyed velvet at 250 GSM is too heavy for a rectangular hijab and should be specified only for structured wraps or for linings.

H2 · FAQ

Is 250 GSM velvet too heavy for a hijab?

For a 180 × 70 cm rectangular hijab, yes — it comes out around 315 g. It works for a structured wrap that is pinned and layered, and it does not work for a hijab worn loose for a full day.

Can I use the same velvet for abaya and hijab?

The same base cloth, at different weights (see the velvet buying guide for the full weight bands). Abaya takes the 220–250 GSM end; hijab takes the 170–200 GSM end. Ordering one weight for both means compromising one of them.

Does burnout velvet shed at the burned edges?

The burned edges are sealed by the process itself and do not fray. The ground between motifs is sheer and needs normal lightweight handling on the cutting table, but it does not shed.

Which side faces the hair?

Pile-in for grip and warmth, pile-out for lustre and colour depth. Most production hijabs are pile-in. See the friction section above.

What is the minimum order?

300 m per colour. At 1.80 m per two hijabs, that is roughly 315–325 finished 180 × 70 cm pieces after cutting loss.

Do you supply the sewn hijab, or only the fabric?

Fabric only. We weave in our own mill and finish at our partner dyehouse; cutting and sewing are done by the buyer's own unit or a garment partner.

Mujia Textile — running our own air-jet looms in Zhuji since 2012.

Related Guides

Keep Reading

How to Verify a Velvet Mill (Not a Trader)
Six checks that separate a velvet mill from a trading company: registry verification, technical questions…
Velvet Pile Direction & Shade Variation: A Buyer's Guide
Why two rolls of the same dye lot can look different, why velvet must be cut one way, and how to specify pile…
Fabric Care & Maintenance Guide
Care-label symbols decoded, plus fabric-specific washing, drying and ironing for cotton poplin, corduroy,…
Sustainable Fabric Certifications in China
Guide to eco-certifications for fabric sourcing from China: OEKO-TEX, GOTS, BCI, GRS and more.
Fabric QC & Inspection Guide
Fabric QC and inspection guide: the 4-point system (ASTM D5430), 10-point system, AQL sampling, defect…
Fabric Testing Methods Guide
The complete fabric testing map for B2B buyers: GSM, density, colorfastness, shrinkage, pilling, strength, pH…

More Velvet & Velour Guides

Burnout (Devore) Velvet CollectionBurnout (Devoré) Velvet: Manufacturing & Sourcing GuideBurnout Velvet Pattern DevelopmentBurnout Velvet vs Solid Velvet: What Actually ChangesHow to Source Velvet & Velour for Home Textiles and ApparelHow to Verify a Velvet Mill (Not a Trader)MJ 7124 Short-Pile Stretch Velvet FabricSilk-Look Velvet vs Real Silk: Faux Velvet Buying GuideSolid Dyed Velvet Fabric, 24 Stock Shades + 40-Colour CardStretch Velvet Fabric SupplierVelvet Cost Structure: 300 m vs 3,000 mVelvet Cutting Yield: 140 cm vs 160 cm, Width by WidthVelvet Fabric Container LoadingVelvet Fabric Manufacturer in ChinaVelvet Fabric WholesaleVelvet Fabric: Burnout, Stretch & CushionVelvet Pile Direction & Shade Variation: A Buyer's GuideVelvet Storage and PackingVelvet vs Velour: The Difference Buyers Actually Need to CheckWhat GSM for Sofa Velvet? Choosing Weight by Use, Not GuessworkWhat Is Viscose Nylon Velvet? CompositionWoven vs Knitted Velvet: What Buyers Get Wrong
✉ Inquiry 📱Chat on WhatsApp