Velvet vs Velour: The Difference Buyers Actually Need to Check
Velvet vs Velour: The Difference Buyers Actually Need to Check
Velvet and velour differ first in construction, not in fibre: velvet is a woven cloth with a cut pile raised from a second warp, while velour is normally a knitted cloth whose loops are sheared open. That single difference produces everything a buyer can feel — velour stretches and drapes close to the body, velvet holds a shape and hangs with weight. Fibre content is a separate question: a 100% polyester velour and a 100% polyester velvet are still different cloths, and a viscose velvet and a viscose velour are too.
The test that settles it in ten seconds is the reverse side and the crosswise stretch. Turn the cloth over: a knitted velour shows loop structure or a fine rib on the back, a woven velvet shows a plain interlacing of warp and weft. Then pull it crosswise: a knit velour gives visibly and recovers, a woven velvet barely moves unless spandex has been added to the ground. Everything below expands on those two checks, and on where our own three velvet lines sit.
H2 · The difference in one table
| Velvet | Velour | |
|---|---|---|
| Construction | Woven (warp-pile) | Usually knitted (cut-loop), sometimes woven |
| Pile | Short, dense, uniform — typically 1–2 mm | Longer, softer, more "furred" — typically 2–3 mm |
| Stretch | None, unless spandex is in the ground | Built in, from the knit structure |
| Drape | Hangs with weight, holds a silhouette | Falls close to the body, moves with it |
| Recovery | Does not need to recover — it does not stretch | Recovers after stretching; cheap velour bags |
| Typical use | Eveningwear, abaya, kaftan, upholstery, curtains | Sportswear, loungewear, robes, budget sofas, kidswear |
| Price floor | Higher — slower to weave, often viscose pile | Lower — knit is faster, polyester is common |
| Reverse side | Plain weave interlacing | Loop structure or fine rib |
H2 · Why the terms are unreliable in the market
Two things make this worse than it should be.
First, "velour" is used loosely for any soft pile fabric. A large share of what is sold as velour in the wholesale market is polyester knit velvet — which is, technically, velour. The word has drifted from a construction term to a hand-feel term.
Second, "velvet" is used as a quality claim. Because velvet is associated with silk and with formalwear, sellers apply it to knit goods to raise the perceived value. A buyer who specifies "velvet" without specifying construction can receive a knit cloth and have no contractual ground to reject it.
The fix is to specify construction, not the word. Write `woven warp-pile velvet` or `knitted cut-loop velour` on the purchase order, alongside the fibre content and GSM. The word alone will not protect you. Our velvet buying guide maps the wider family (velveteen, panne, burnout) the same way.
H2 · Three checks you can run on a sample
1. The reverse side.
Turn the sample over. A knitted velour shows loop structure, a fine rib, or a slightly stretchy hand. A woven velvet shows a flat interlacing — you can pick out individual warp and weft threads crossing.
2. Crosswise stretch.
Hold 20 cm of cloth and pull across the width. A knit velour extends visibly and springs back. A woven velvet resists; if it gives at all, the ground contains spandex and the supplier should have told you.
3. The edge.
A woven velvet has a selvedge — a finished edge where the weft turns back, often with a visible fringe or a tighter weave. A knitted velour is usually delivered as a tube or a slit-open width without a true selvedge.
A fourth check, if you have a lighter: pile from a knit tends to be longer and less uniform, and it melts rather than chars if the fibre is polyester. That test only tells you the fibre, not the construction — use it after the first three.
H2 · Where our three lines sit
We make both constructions (the full range is on our velvet fabric page). Being precise about which is which matters more than claiming one is better.
| Line | Code | Construction | Composition | GSM | Width |
|---|---|---|---|---|---|
| Solid-dyed velvet | MJ-VSL01 | Woven warp-pile | 80% viscose / 20% nylon | ~250 | 140 / 160 cm |
| Burnout (devoré) velvet | MJ-VBR01 | Woven warp-pile, caustic-burned | 80% viscose / 20% nylon | 170–220 | 140 cm |
| Stretch velvet | MJ7124 | Warp-knit with spandex | 95% polyester / 5% spandex | 250 | 155–160 cm |
Two notes a buyer should read carefully.
MJ-VSL01 and MJ-VBR01 are woven. No spandex, no stretch. They hang with weight and hold a shape — which is what abaya, kaftan, dirac and eveningwear need. If you want stretch from these two, you are looking at the wrong line.
MJ7124 is warp-knit. It sits in the knitted family, with the spandex knitted into the ground so the stretch is four-way and recovers. Its pile is short and close-cropped rather than long and furred, so it reads as a velvet in the hand while behaving like a knit in the cut room (construction trade-offs: woven vs knitted velvet buyer's guide).
What we do not make is a long-pile circular-knit velour for loungewear and budget upholstery. If that is the requirement, say so early — we will tell you rather than substitute.
H2 · Which one to specify
Choose woven velvet (MJ-VSL01 / MJ-VBR01) when:
- The garment has to hold a silhouette — abaya, kaftan, structured dress, tailored jacket
- The end use is upholstery or curtain and you need dimensional stability
- You want a viscose pile for lustre and a dry, cool hand
- The buyer's pattern was developed on a woven and the fit depends on it
Choose warp-knit stretch velvet (MJ7124) when:
- The garment is fitted and has to move — bodycon, dancewear, leggings, stage costume
- You need four-way stretch with recovery
- You want a bright, close-cropped face rather than a deep pile
- You are printing or embossing and want the surface to stay flat
Neither, if:
- You need a deep, soft, long pile for robes or cheap sofas — that is circular-knit velour and it is a different supply chain
H2 · The mistake that costs the most
The expensive mistake is not choosing the wrong word. It is approving a sample on hand feel and then receiving bulk on a different construction, because the PO said "velvet" and the mill delivered what it calls velvet.
Two lines on the purchase order prevent it:
Construction: woven warp-pile velvet (not knitted) Stretch: none — reject if crosswise stretch exceeds 3%
If a supplier cannot accept those two lines, the specification was never agreed.
Frequently Asked Questions
Is velour cheaper than velvet?
Usually yes, and for a structural reason rather than a quality one: knitting is faster than weaving, and velour is commonly made in polyester. A viscose velour can cost as much as a polyester velvet — fibre and construction move the price independently.
Can velvet stretch?
Woven velvet does not stretch. If it does, spandex has been added to the ground — which is legitimate, but it is a different product and should be specified as stretch velvet. Our MJ7124 is warp-knit and stretches by construction.
Is velour lower quality than velvet?
No. They are different constructions for different end uses. Velour is the correct choice for loungewear, robes and budget upholstery; velvet is the correct choice where a garment has to hold a shape. Calling one better is a category error.
Which is warmer?
Velour, generally — a longer pile traps more air. But pile length varies more within each category than between them, so the label is a weak guide to warmth.
Can I get a woven velvet with stretch?
Yes, by adding spandex to the ground warp, but it is uncommon and it changes the hand. If you need stretch and a woven look, a warp-knit like MJ7124 is usually the more practical answer.
How do I write this on a PO so it is enforceable?
Specify construction, fibre content, GSM and width, and add the stretch tolerance. "Velvet, 80% viscose / 20% nylon, 250 GSM, 140 cm, woven, no stretch" is enforceable. "Velvet" is not.